There was very good day, Unfortunately in next month I will do nothing with my project because of my absence. Probably I will think how to make quite tidy electrical and signal bus. Please find attached below some pictures o CDU-FMS progress. I made every buttons:)
Monthly Archives: August 2013
Last time I had not opportunity to push forward my project. But today I spent whole day to make some progress. Today I worked on light panels. I changed my mind and I made first layer of every panel again. Now I made it use laminated plate for engraving. Below You can compare old and new […]
Dear All, I had a few hours of free time, and I have started to build gear lever mechanism. Of course, it is not finish yet – I have to assembly better springs and handle Months ago I found the idea at the best Home CRJ WEBsite: http://crjsim.com (www.xplanecrj.com) Here You can see, how does it work: https://www.youtube.com/watch?v=G1x2EoXC51s […]
Hello. I made some progress in autopilot panel – I can say – I finished this stage: Ap-panel is connected to the X-plane by: SimOutXL – hardware, and XPUIPC, HSC (Home sim cockpit) – software. Communication (input and output) between Panel and X-plane is working perfectly (I didn’t expect that it would work so good without any problems). […]
Hello. In most of passenger planes flightdecks, we can find rotary encoders, and also double shaft rotary encoders. Single encoders are cheap, but duble – very expensive. How I can solve issue related to very expensive double encoders. Please find attached some pictures below;
crj200athome 